The bread refrigerated truck is small and exquisite, easy to transport, and can quickly travel through the urban areas. However, there are some problems that need to be prepared. There are some special circumstances that must be handled correctly to ensure the quality of the transportation. I will briefly introduce some issues below. And disposal methods.
First of all, I would like to say a few preparatory work before transport. Only sufficient preparation work will avoid some problems in the transportation process. When the goods are shipped, the other party to the goods should be placed on the double-sided pallets of the bread refrigerated truck and the bread should be refrigerated. Do not cover some plastic film on the pallets, otherwise it will hinder the circulation of the air-conditioner, and it can not block the floor of the goods line. This is the key to ensure the uniform temperature protection of the goods during the refrigerated truck transportation. Commonly used ventilation aluminum floor, or flat non-slip floor, this non-slip floor is generally transport companies or dairy transport companies in the use of refrigerated trucks, pay attention is not to dump cargo in the refrigerator car vents, to prevent obstruction Air-conditioning leads to a short-circuit of the air-conditioning. If the top of the goods is stacked, it is better to keep the distance from the top of the refrigerated truck to a distance of not less than 225mm. When loading the goods, avoid the height of the goods being stacked too high and ensure that the height of the air vents of the refrigerated truck is not higher than the level of the vents of the refrigerated truck. Being blocked or being too close to the cargo will affect the temperature in the refrigerated compartment, even Caused by the normal operation of refrigerated trucks refrigeration units, once the vents blocked, we can not guarantee the circulation of cold air will cause local temperature inside refrigerated trucks increased. The design of defrosting of refrigerating units of refrigerated trucks adopts air induction. When the goods are too close to the vents, the coils in the evaporators of refrigerated trucks will have frost and ice, and the defrosting will start only when the The defrosting will stop when the temperature of the refrigerated truck coil rises to a certain temperature, then the above situation will occur repeatedly when the cargo is too close to the vent of the refrigerated truck, resulting in no decrease in the temperature of the refrigerated truck box, which is visualized as repeated defrosting. in fact refrigerated cargo vehicles piled too high a problem.
Fuel Quick Connector with double seal ring radial seal structure, rubber modified by O - ring, mainly for fluid and the physical, chemical properties of custom, prevent aging, corrosion, swelling; O - ring have intermediate spacer ring separated, two sealing rings of the corresponding event space, the rubber matrix bonding does not occur, the external O-ring using synthetic rubber, enhanced mechanical properties, prevent air aging. Sealing ring and a spacer ring through the outer ring of the elastic bayonet device firmly fixed in the shell, does not produce seal off and shift phenomenon produced. Greatly ensure the safety of the seal.
The working environment of the fast fuel joint is not too many constraints. It is mainly through air, fuel, oil, oil and gas and other media, can work in the case of about 10bar over pressure. With regard to working temperature, the fuel fast coupling can be within the engine area at a temperature of about ~+110 in the short time of the -40 degree within the engine area (about half an hour)..
Fuel Quick Connector,Auto Quick Connector,Quick Connect Fittings
Linhai Shinyfly Auto Parts Co.,Ltd. , https://www.chinashinyfly.com