What should be paid attention to when installing the bucket elevator

Bucket elevator is a kind of equipment that specially transports materials vertically. The range of materials conveyed by such equipment is extensive, and the market demand is more and more. The bucket elevator is not integrated like a screw conveyor. The bucket elevator is a section. When it is installed, it is also accumulated in one section. Therefore, the bucket elevator is installed at the site. Special care must be taken to avoid unnecessary mechanical failures and potential safety hazards. For this reason, special editors of Gent Vibration today explain to you what are the issues to be aware of when installing a bucket elevator? 1. It should be noted that the entrance shelter construction is to be standardized. The main problem of the bucket elevator is the height of the shelter, which prevents the impact of the material from falling down. 2. The mounting area of ​​the shelter must be sufficient. The specification requires that the shelter must be erected within 3m from the low shelf and 5m from the overhead shelf. Left and right, the width is slightly larger than the frame width. 3. Pay attention to the erection of the equipment's unloading platform. The stability of the unloading platform has a direct impact on the safety of the operators. The main cause of the derrick falling from the sky is caused by the lack of standardized installation of the unloading platform. The requirements for the erection of the unloading platform are to be made into a stand-alone platform, that is, the erection of the platform can only take the form of a single pole from the ground or a pull of a building, and cannot be connected with the scaffold to avoid affecting the stability of the scaffold. Sex. 4. It should be noted that the installation of the wall brackets and cable wind ropes on the equipment should be standardized. The wall brackets and the cable wind ropes are devices for stably lifting the frame body. The big problem is that the installation is not standardized and the cable wind rope material requirements Be sure to use a round wire rope, and install all the proper tension and so on. 5. The problem to be noted is that cranes must be used to lift the crane body when it is hoisted. Workers must also perform safety measures when working in the air. Each staff member must wear a seat belt. 6. It should be noted that the bolts connecting the cabinets must be tightened, so that they cannot be loosened. In addition, all the components on the bucket elevator must be installed in one step. The above are the problems that we need to pay attention to when Jinte Vibration Xiaobian explains to the bucket elevator installation site. For more information on the use of bucket elevators, please visit our website to learn more or call: II Fourteen-hour service hotline is at your service