How to do the daily maintenance of pressure transmitter? The staff of Anhui Hualite Automation (Group) Co., Ltd. will introduce us to the following:
1. Check the size of the mounting hole: If the size of the mounting hole is not appropriate, the threaded portion of the sensor is susceptible to wear during installation. This will not only affect the sealing performance of the equipment, but also make the pressure sensor unable to fully play its role, and may even cause potential safety hazards. Only suitable mounting holes can avoid thread wear (Thread Industry Standard 1/2-20 UNF 2B). Mounting holes can usually be used to test mounting holes to make appropriate adjustments.
2. Keep the mounting holes clean: Keeping the mounting holes clean and preventing clogging of the melt is important to ensure proper operation of the equipment. Before the extruder is cleaned, all pressure sensors should be removed from the barrel to avoid damage. When the sensor is removed, the molten material may flow into the mounting hole and harden. If these residual melts are not removed, the top of the sensor may be damaged when the sensor is installed again. The cleaning kit can remove these frit residues. However, the repeated cleaning process may deepen the damage caused by the mounting hole to the sensor. If this happens, steps should be taken to increase the position of the sensor in the mounting hole.
Pressure Transmitters
3, choose the right position: When the pressure sensor is installed too close to the production line, the unmelted material may wear out the top of the sensor; if the sensor is installed in the position too far between the sensor and the screw stroke may A stagnant zone of molten material can occur, where the molten material may degrade and the pressure signal may transmit distortion; if the sensor is too deep into the barrel, the screw may touch the top of the sensor during rotation and cause damage. In general, the sensor can be located on the barrel in front of the screen, in front of the melt pump, or in the mold.
4. Carefully clean; all sensors should be removed before cleaning the extruder barrel with a wire brush or special compound. Because both of these cleaning methods may cause damage to the sensor's diaphragm. When the barrel is heated, the sensor should also be disassembled and wiped on top using a soft cloth that will not wear, and the sensor hole needs to be cleaned with a clean drill and guide bush.
Twin Screw Pump
Twin screw pump is positive displacement turns round pump. The pump has characteristics of great flow, high pressure, no pulsation, small vibration, low noise level, reliable running and long service life. Different design of spirit line type is applied for transport of different medium. There are different mechanical seal to ensure desirable of spirit transporting
The pump can use cooling double mechanical sealing system which is independently lubricated and compensated pressure, it can be applied to transport crude oil with gas and high viscosity medium. The pump is the ideal equipment for petroleum industry, petroleum industry and synthetic rubber industry.
Twin screw pump can transmit various lubricating or non-lubricating, high or low viscous liquid, and transmit medium with a little granule by using particular material.
Petroleum and Petroleum Industry: handing various lubricant hydraulic oil, crude oil, residual oil, heavy oil, diesel oil, gasoline and etc.
Ship Building Industry: Transporting and pressing pump for various light or heavy fuel oil, waste oil, dirty oil and sewage sludge cabin bottom.
Chemical Industry: Transporting and filling pump for various acid, alkali and salt solution, resin, glycerin, paraffin and cosmetics emulsion.
Plant Industry: Handing printing ink, pigment, various paint and dope.
Food Industry: Handing alcohol, beverage, honey, sugar juice, toothpaste, milk, cream, soy sauce, and animal oil, vegetable oil, chocolate and medium with high viscosity.
Traffic Industry: loading, unloading and filling oil goods for gas stations and tankers.
Single Screw Pump,Triple Mini Screw Pump,Twin Well Screw Pump,Twin Screw Pump Pressure
Tianjin RongHeng Group LLC , https://www.wholesale-water-pump.com