All-electric raised car should pay attention to the safe operation

All-electric upshift vehicles, also known as all-electric stackers, have become the main material handling equipment in the current material handling process. With the increasing use of electric series material equipment, safety operations have also become People are most concerned about the problem, which should pay attention to what safe operation method in the operation? Xiao Bian here for you to sort out some points:

1. All electric-enhanced vehicle operators are not allowed to drunk after driving, overweight, and speeding, and are prohibited from sharp braking and sharp turns. It is forbidden for an all-electric raised car to enter a place where solvents and combustible gases are stored.

2. The all-electric high-rising vehicle safety device must be complete and complete, with sensitive and effective components and good technical performance. It is forbidden to carry the sick car with a sick car. Usually, more maintenance must be done for all electric motors, and all parts must be carefully checked.

3. Maintain the standard driving state of the all-electric raised car. When the fork is off the ground, the fork is 10-20 cm above the ground. When the all-electric rise car stops, the fork falls to the ground and travels in a poor road condition. When working, its weight is properly reduced, and the all-electric increased vehicle speed should be reduced.

4. When an all-electric upshift vehicle is in motion, if the electric controller loses control, the total power supply is disconnected in time.

5. When using an all-electric high-rise vehicle, special attention should be paid to timely charging of the battery and correct maintenance of the battery. When the battery is charged, it is necessary to pay attention to the method, not only to make the battery fully charged, but also not to cause the battery to be overcharged; when the battery is in the state of a loss of power, it is necessary to charge the battery several times, and then it can be restored to the normal state; often the battery is checked. Distilled water is sufficient, if not enough, distilled water should be added in time.

6, in the all-electric increased car operation, as long as possible to use long-distance acceleration for a long time, when the all-electric rise car start, after the speed increase, stabilize the accelerator pedal, such as good road conditions, stacker cars will continue to accelerate. When the stacker needs to decelerate, relax the accelerator pedal and gently step on the brake pedal. This will make full use of the deceleration energy. If the all-electric upshift vehicle has a regenerative braking function, the kinetic energy during deceleration can be recovered. When the vehicle descends on the ramp, do not disconnect the electric drive motor drive circuit, gently depress the brake pedal, so that the all-electric riser operates in the regenerative braking state, the use of the vehicle's kinetic energy, reduce the battery's energy consumption.

7. Do not mistake the “Forward, Reverse” direction switch as a steering switch during all-electric upshift operation. Do not use the brake pedal directly to the end unless emergency deceleration is required. During the use of the vehicle, when the battery power is found to be insufficient (which can be obtained through the power meter, the power loss indicator and other alarm devices), the battery should be charged as soon as possible to prevent the battery from being over-discharged.

8. During the operation of the all-electric upshift vehicle, do not always use emergency braking during high-speed driving; otherwise, it will cause great friction to the brake assembly and drive wheel, shorten the service life of the brake assembly and the drive wheel, and even Damaged brake assembly, drive wheel.

9. When the electric all-enhanced car is not in use, please lower the fork to the lowest position to prevent the piston rod of the cylinder from being exposed to rust in the air for a long time; the driving wheel and the front wheel must be ensured that no debris such as shredding is wound; Stay closed.