High-capacity, high-efficiency equipment is pursued by every user, but in addition to the equipment itself, the operations in production are closely related to its efficiency. Taking cone crushing as an example, the following production recommendations can improve efficiency to a certain extent and achieve large capacity.
1. Adjust the size of the closed side discharge opening to change the output.
The output of the equipment can be achieved by adjusting the size of the closed discharge opening.
When the size of the closed discharge port is larger, the higher the output of the cone is, the worse the quality of the finished product is. On the contrary, the smaller the size of the closed discharge port, the smaller the output and the better the quality of the finished product, so the manufacturer can Actual needs are adjusted.
2, the belt conveyor evenly feeds
When feeding, the belt machine is required to input the material evenly. The material should meet the requirements of the crushing material of the cone crusher. Too much or too little material will affect the production efficiency of the equipment;
In addition, the operator needs to pay close attention to the discharge condition of the discharge port of the cone crusher , control the speed of the belt conveyor, and ensure normal feeding and discharging.
3, the best packed with feed
When installing the feeder, pay attention to the speed at which the ore enters the crusher and the corresponding drop relationship. Usually, due to the constant speed of the conveyor, the only drop height of the ore can be selected. At the same time as filling the mine, it should be noted that the feeding can not be used for a long time, and the height of the heap in the feeding device should be controlled.
4, reduce the mineral powder into the cylinder liner and extend the service life of the seal
Whenever the liner is replaced, check that the dynamic cone seal is intact. Under normal circumstances, when the wear gap between the dust seal ring and the slip ring is greater than 1.5mm, the dust seal should be replaced to prevent the mineral powder from entering the cylinder liner and causing damage to the spindle and other components.
5, the lubricant temperature should be balanced
Since the lubrication and heat dissipation of the main lubrication parts of the crusher such as the main shaft, the eccentric sleeve, the eccentric shaft, the frame bearing, the spindle adjustment piston, the sliding bearing surface, and the gear rotation are mainly dependent on the lubrication system, it is very important to select a suitable cooling and heat dissipation device.
6, pay attention to the bolt seal of the dust seal slip ring
When the materials accumulated on the beam are not cleaned in time, the bolts of the fixed slip ring move relative to the stacked materials and cause the tail of the bolt to wear. If there is a problem with the fixing condition of the slip ring, careful technical inspection must be carried out to avoid the adverse consequences caused by the slip ring.
7, regular inspection and maintenance to extend equipment life
1) Regularly check the water cooler, filter and oil pump of the equipment to measure the oil temperature. Under normal circumstances, the required oil return temperature does not exceed 60 degrees, and the temperature is too high for the equipment;
2) Regularly check the dust-proof drainage of the water seal of the cone crusher. If there is no water or the amount of water is small, it should be stopped in time, otherwise it will seriously affect the equipment;
3) Every once in a while, the operator should check the oil pressure of the cone crusher lock cylinder, especially in the case of serious wear of the lining plate, pay more attention to the lining plate fixing bolt on the adjusting ring, once loosened Causes the liner to loosen. For the newly changed liner, it is necessary to stop the parking once after 24 hours of work.
Special Purpose Crane,Durable Metallurgy Electric Hoist,Sand Gravel Hydraulic Grab Bucket,Intelligent Special Purpose Grab Crane
HENAN MAJOR INDUSTRIES IMP. & EXP. CO., LTD. , https://www.henanminingcrane.com