Model NO.: CG-D
Position of Pump Shaft: Horizontal Pump
Pump Casing Combined: Radially Split Case
Mounting Height: Suction Centrifugal
Impeller: Closed
Usage: Pump, Pumps, Condensate Pump, Ash Pumps, Circulating Pump, Boiler Feed Water Pump
Material: Cast Iron or Stainless Steel
Warranty: 12 Months
Trademark: spmc or OEM
Transport Package: Wooden Case
Origin: China
HS Code: 841370
| Parameters: | |
| Capacity: | 3.7-330m3/h |
| Head : | 75-1050m |
| Power: | 4-1250kw |
| Speed: | 2950rpm |
Model CG-D pump is a horizontal multi-stage centrifugal pump and suitable for transporting pure water (with te contaied foreign matters' content less than 1% and grainness less than 01mm) and liquid of both physical and chemical natures similar to those of pure water.
 CG-D model model middle and low pressure boiler water supply pump is applicale to transport medium with temperature of not higher than 105ºC,and is also applicale for small boiler water supply or transporting medium similar to hotwater.
performance range of model CG-D series
Flow:3.75~185m3/h       Corollary power:4.0~400KW
Head:69~684m              Intel diameter:40~150mm
CG-D model hypo-high pressure boiler water supply pump is applicable to transport medium with teperature of not higher than 160ºC,and is also applicable for small boiler water supply or tansporting medium similar to hot water.
Performace range of model CG-D series.
  For this series horizontal multi-stage cetrifugal pump,both ends of it are supported,the casin portion is in a sectional form,it is conected to and actuated by a resilient cltuch and rotating direction of it,viewing from the actuating end,is clockwie.
 Stator portion
 Consist of suck-in section,middle-section,spitting section,gue vane,packing etc., which are linked together with a take up bolt,with both suck -in and spitting mouths vertically upward.
 Rotor portion
 Consist of a shaft,impeller,balanceing disk,muff ect.parts
 Bearing portion
 The whole rotor is supporte by the roller bearing or siliding bearings on both ends of shaft and the bearings are lubricated with grease or 20 # engin oil
 Cooling and seal of pump
 The joint-part between suction section,intermediate section and discharge section with coaedwith molybdenum disulfide lubricating grease s esal.Rotor and fixed parts will be seled by seal ring,guide-vne jecket and packing.The packing tensible dip by dip unload run should be frbid.The seak ring and guide vane jacket should be replcd if they are t worn t be uesd any mre and even do harm to pump work.There is spare shaft sleeve near shaft seal to protect shaft of pump.
Â
An excavator peel grapple is a specialized attachment for an excavator that is used to remove the outer layer or peel of a material, such as bark from trees or the top layer of soil. The grapple is designed with sharp teeth or blades that dig into the material and then lift and remove it from the ground. This type of grapple is commonly used in forestry, landscaping, and construction industries.
Orange Peel Grapple,Excavator Orange Peel Grapple,Orange Peel Grapple For Sale,Rotobec Orange Peel Grapple
CATSU Hydraulic Machinery Equipment Co.,Ltd , https://www.cattiltrotator.com