Cause Analysis of Gear Pump Motor Overheating
Gear pump is mainly used in oil, chemical, metallurgy, mining, power plants and other industries of oil media transfer, pressurization, fuel injection, and large oil and thin oil machinery and equipment circulation, in all types of machinery and equipment can do lubrication pump use.
Motor overheating gear pump is often in the course of the work of the problem, the specific analysis and testing are as follows:
1, the use of (flow, head) than the gear pump design requirements?
Select the appropriate type of motor spectrum 2, the proportion of more than gear pump gear motor configuration?
Configure the appropriate gear motor oil pump 3, packing gland pressure is too tight or mechanical seal spring is too tight?
Re-adjust the gland or mechanical seal spring compression 4, the pump assembly quality is poor, there is friction or motor and the pump shaft is not the same?
Check the assembly quality, eliminate assembly problems?
For the above conditions, one by one to do the analysis to find out the real cause of motor overheating, in accordance with the corresponding fault, maintenance treatment.
This article Keywords: gear pump 　　 Oil pump
Hyperboloid Mixer
Hyperboloid mixers are widely applied in environmental protection, chemistry, energy and light industry where the solid, liquid and gas are interflowing, especially in the sewage treatment process of coagulative precipitation tank, equalization pond, anaerobic pond, nitration pond, and denitrifying pond.If the mixer is dry type installation, it's especial suit for the environment with high temperature, high concentration and corrosive liquid.
Hyperboloid Mixer,Low Speed Hyperboloid Mixer,Sewage Hyperboloid Mixer,Wastewater Hyperboloid Mixer,Hyperboloid Mixers
YIXING HOLLY TECHNOLOGY CO.,LTD. , https://www.watertreatment-machine.com