Pressure on China's wind power policy, the United States wants to occupy the commanding heights of new energy

    A spokesman for the U.S. Trade Representative Office recently said that China has agreed to stop providing subsidies to wind power companies that use domestically produced, not imported, components. According to expert analysis, the U.S. move is intended to seize the commanding heights of global new energy and may further pressure China to reduce wind power subsidies. "USA Today" quoted US Trade Representative Kirk on his website as saying that China has agreed to stop providing subsidies of 6 to 22 million U.S. dollars. Kirk also said that this helps provide a fair environment for U.S. clean technology companies and workers.

    Shen Hongwen, researcher of China Investment Advisor New Energy Industry Research Institute, pointed out that the United States currently urges China to cancel its wind power procurement subsidy in order to increase the competitiveness and sales of wind power companies in the United States and stimulate the development of its wind power industry. “The United States is about to enter the 2012 election cycle, and the Obama administration is facing the pressure of change. Therefore, the success in foreign trade negotiations can play a role in its re-election.” Miao Yingchun said that if Obama’s economic policy cannot put the United States The economy brings a shadow, and economic problems will become a huge stumbling block to its campaign.

    The U.S. government hopes to find an engine that guides the economy out of the bottom, and new energy is seen by the Obama administration as a new growth point for the U.S. economy. It is extremely important for it to seize the commanding heights of the global new energy. In the past two years, with the continuous development of the wind power industry in China, the US market has more and more restrictions on China. Statistics show that by the end of 2010, China’s total installed wind power capacity has surpassed that of the United States, ranking first in the world. But Shi Pengfei, deputy director of the Wind Energy Professional Committee of the China Renewable Energy Society, said that whether it is the per capita wind power or the share of wind power in the national economy, compared with developed countries, China's ranking in the world is very backward.

    Song Liang, an analyst at the China Circulation Productivity Promotion Center, believes that American wind power companies may wish to establish wind power installations in China in the form of joint ventures, and even become the mainstream of China's wind power installed market. "However, the self-digesting capacity of China's wind power installed companies is relatively strong. In the long run, the cancellation of procurement subsidies will not have a big impact on the industry," Song Liang said.

    It is widely believed in the industry that China’s suspension of subsidies for wind power companies is unequal for both China and the United States. Song Liang pointed out that if China cuts subsidies, the United States has not cancelled the barriers to the development of China's new energy industry, which is unfair to Chinese companies. Therefore, the subsequent development of this news remains to be seen.

    Tensioner Bearing

    Someone may not clear that it would change the time, resulting in poor engine performance even damage to valves, if the teeth on the belt jump over the teeth of gear. So that`s why tensioner Bearing exists. It keeps belt tension never be too low or too high.

    The tensioner bearing should be replaced when replacing the timing belt. And we are professional for the United States, Europe, Japan and other countries, to provide high quality and affordable tension bearing.

    belt Idler Pulleys are provided with a series of radial reinforcing ribs to prevent deformation caused by the wedging action of the belt.

    The timing belt tensioner is used to keep tension on the timing belt. The timing belt is a rubber belt that runs over and through a series of pulleys and gears. Over time, due to age and heat, the belt will stretch out. As the belt stretches it can become loose, so the tensioner needs to adjust the belt as needed to keep it tight.


    Tensioner Bearing,High Strength Tensioner Bearing,Tensioner Roller Bearing,Belt Idler Pulley,Timing Belt Tensioner

    NINGBO DGOFEN AUTO TRADE CO., LTD , https://www.dgofen.com

    Previous Post: Eight ways to reduce SolidWorks file size
    Next Post: China Valve Signs 50 Million High-End Valve R&D and Supply Agreement
    Home
    Recent Posts
    • Three enterprises in Jiangxi have obtained produ…
    • Detailed explanation: how to monitor the camera&…
    • Analysis of solar photovoltaic technology
    • DuPont Brings Leading Agrochemical Technology to…
    • ExxonMobil and Shanghai China Fuel Strategic Coo…
    • Tongyu Heavy Industries has successfully rolled …
    • The application of the latest cold-ring loop gas…
    • Yingkou builds a new material processing equipme…
    • Small Weather Station Features and Applications
    • April industrial product sales rate was 98.1%
    • High-end CNC machine tool manufacturers have gre…
    • Mould Capital Chengdu Industry Transformation Eu…
    • Goodyear recalls nearly 40,000 Wrangler silent a…
    • Yangzhou New Material Industrial Park unveiled
    • China's Ministry Takes Off Japan and Enters …
    • Competitive competition for construction machine…
    • China Haida acquires Suzhou Xunwei to make up fo…
    • Configuration data has the mystery of the latest…
    • LLDPE production equipment first installed "…
    • Lanbao Launches Long Distance Small Angle Photoe…